Tecfrigo ISOLA HOT Serie Instalación Y Uso página 7

6. CONTROLS
The appliance is supplied with adjusting controls located in a protected panel on the front. 1. Cover
lifting switch:
Position II lifting Position 0 still Position I lowering.
internal light. 3. Plate switch:
Thermostat:
temperature.
the temperature set-point, which can be changed by pressing button
figure 5).
7. CHECKING CORRECT OPERATION
CHECK THAT: 1.
The plug is connected. . The cover is open.
4. Heater lamps are switched on. . The appliance is set to the required temperature.
machine away from inflammable material or any risk of explosion.
8. CLEANING THE HEATED PLATES
1. Switch off the appliance by turning off the power switch and pulling the plug out of the socket.
2
. Before cleaning make sure that all heated parts have cooled down. . Clean the appliance with a
sponge dipped in water and a little sodium bicarbonate, then dry with care. . Switch on the mains.
Operator's guide
to switch on the plate resisstor.
to adjust the plate's temperature. Press button
2
5
7
2. Light switch:
to switch on the
4. Thermometer : to display the plate's
5 "SET or P"
6 "UP" or button 7 "DOWN"
3.
The plate switch is on (green light on).
6.
3
4
UK
once to display
(see
Keep the
NL
DK
FIN
GR
CZ
EE
LV
LT
M
PL
SK
SLO
I
D
E
F
P
S
B
H