Publicidad
Idiomas disponibles
Idiomas disponibles
Caution: Devices in hanging installations may cause severe injuries when crashing down! If you have
doubts concerning the safety of a possible installation, do NOT install the device!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the device's
weight.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Mount the device to your trussing system using an appropriate clamp.
For overhead use, always install an appropriate safety bond.
You must only use safety bonds complying with DIN 56927, quick
links complying with DIN 56926, shackles complying with DIN EN
1677-1 and BGV C1 carbines. The safety bonds, quick links,
shackles and the carbines must be sufficiently dimensioned and
used correctly in accordance with the latest industrial safety
regulations (e. g. BGV C1, BGI 810-3).
Please note: for overhead rigging in public or industrial areas, a
series of safety instructions have to be followed that this manual
can only give in part. The operator must therefore inform himself
on the current safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by
incorrect installations or insufficient safety precautions!
Pull the safety bond through the attachment eyelet and over the
trussing system or a safe fixation spot. Insert the end in the quick
link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already held the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!
DANGER OF FIRE!
DANGER TO LIFE!
23/55
00027030.DOC, Version 1.2
Publicidad
