Publicidad
Idiomas disponibles
Idiomas disponibles
3.6 I Ending the cleaning cycle
• To prevent damage to the equipment:
Do not pull on the cable to remove the appliance from the pool. Use the handle.
-
- Do not leave the appliance to dry out in sunlight after use.
- Store all the elements away from sunlight, humidity and bad weather.
- Screw the protective cap back on if you unplug the control box power cord.
• Once the cycle is complete, the appliance stops and the LED on the control box switches off.
• To stop the appliance during cleaning, press
• Carefully pull on the floating cable to bring the robot to the edge of the pool.
• When the cleaner is within arm's reach, pick it up by the handle and lift it gently out of the pool so that the water it
contains drains into the pool (see figure
• Place the cleaner on the ground or vertically at the location provided on the caddy (available as an optional extra) for
it to dry out quickly. Then store it with the control box away from sunlight and any splashes.
Tip to prevent the floating cable from becoming tangled
The appliance's behaviour is strongly impacted by the tangling of the cable. A cable that is correctly untangled
will guarantee better coverage of the pool.
• Untangle the cable and lay it out in the sun so that it returns to its original shape.
• Then wind it up carefully and place it on the caddy handle (available as an optional extra) or on a fixed
support.
10
; the LED goes out.
).
Publicidad
