Worx Chopper WX801.X Manual Original página 16

WARNING: To be accurate, an estimation of exposure
level in the actual conditions of use should also take
account of all parts of the operating cycle such as the
times when the tool is switched off and when it is running
idle but not actually doing the job. This may significantly
reduce the exposure level over the total working period.
Help to minimize your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
16
Category Type
20V Battery WA3550
WA3550.1
WA3551
WA3551.1
WA3553
20V Charger WA3860
WA3880
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.
OPERATING INSTRUCTIONS
INTENDED USE:
The machine is intended for cutting, roughing and
brushing metal and stone materials without using water.
For cutting metal, a special protection guard for cutting
(accessory) must be used.
Capacity
ASSEMBLY AND OPERATION
1.5Ah
1.5Ah
BEFORE OPERATION
2.0Ah
Removing the Battery Pack
2.0Ah
Charging the Battery Pack
4.0Ah
ASSEMBLY
2.0A
2.0A
NOTE: Before using the tool, read the instruction
book carefully.
ACTION FIGURE
See Fig. A1
See Fig. A2