Worx Chopper WX801.X Manual Original página 17

Lock the spindle and assembling metal
cutting disc/abrasive cutting disc /
grinding disc
NOTE: Press and hold the
spindle lock button to lock the
spindle.
NOTE: Make sure that the metal
cutting disc/abrasive cutting
disc /grinding disc is assembled
firmly.
WARNING! Before any work on
the machine itself, remove the
battery pack.
Lock the spindle and removing metal
cutting disc/abrasive cutting disc /
grinding disc
Adjusting Wheel Guard for grinding/
cutting
Note: Remove the battery pack
before making any changes to the
tool. For work with grinding or
cutting discs, the protection guard
must be mounted. Use the correct
type of disc for your application.
If the power tool is intended to
perform any cut-off operations, a
guard specific for this operation
must be installed.
Installing the Battery Pack
WARNING: Before inserting the
battery pack, make sure that
the ON/OFF Switch is in OFF
position.
WARNING: When replacing the
See Fig. B battery pack, do not insert the
battery pack until the metal
cutting disc/abrasive cutting disc /
grinding disc comes to a complete
stop!
OPERATION
Using On/Off Switch
Note: Depress the On/Off switch
See Fig. C
forward to lock-on button. Your
switch is now locked on for
continuous use.
Hand grip areas
Rough Grinding
WARNING! Never use a cutting
See Fig.
disc for rough grinding
D1,D2,D3
applications. This can cause bodily
damaged by using the tool for
wrong applications.
Cutting
See Fig. E
17
See Fig. F
See Fig. G
See Fig. H
See Fig. I