Publicidad
Idiomas disponibles
Idiomas disponibles
BELT CHANGING AND BRUSHROLL CLEANING
Brushroll
5. Check and clean end cap areas. See
Brushroll Assembly picture on this page.
BRUSHROLL CLEANING
NOTE:
In order to keep cleaning
efficiency high and to prevent damage to
your vacuum cleaner, the brushroll must be
cleaned every time the belt is changed.
The brushroll must also be cleaned
according to the following schedule:
Vacuum Cleaner
Use
HEAVY-(used daily) every week
MODERATE -(used
2-3 times/week)
LIGHT -(used 1
time/week)
IMPORTANT
Turn off and unplug vacuum cleaner from
electrical outlet. Check and remove hair
string and lint build-up in the PowerMate
brushroll and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush unit area.
Carefully remove any string wound onto
the brushroll and end caps.
Clean Brushroll
every month
every 2 months
BRUSHROLL ASSEMBLY
End Cap
TO REPLACE BELT
1. Install new belt over motor shaft, then
over belt path.
NOTE:
See REPLACEMENT PARTS for
part number and purchase details (page 5).
2. Place brushroll assembly back into
PowerMate
3. Line up and insert the tabs on the front
edge of the cover into the slots on the
®
front edge of the base.
- 11 -
Belt Path
End Cap
Brush Unit
Brushroll
®
.
Publicidad
