Kenmore PowerMate Nozzle Manual De Uso Y Cuidado página 13

Review this table to find do-it-yourself solutions for minor performance problems. For any
other assistance needed, call 1-877-531-7321 (US) / 1-844-608-3081 (CA).
WARNING
Always turn off and unplug vacuum cleaner before performing maintenance to the
PowerMate®. Failure to do so could result in electrical shock or personal injury.
PROBLEM
Full or clogged dust bag.
Clogged airflow passages.
Dirty filters.
Wrong pile height setting.
Wrong power level selected.
Hole in hose.
Poor job of dirt
pick-up.
Worn PowerMate
Worn or broken belt.
Dirty brushroll or end caps.
Canister hood open.
Tripped overload protector in
PowerMate
PROTECTOR (page 9).
Hose or hood electrical
connections.
Vacuum cleaner Tripped overload protector in
starts but shuts PowerMate
off. PROTECTOR (page 9).
Tripped thermal protector in
canister.
TROUBLESHOOTING
POSSIBLE CAUSE
®
brushroll.
®
. See OVERLOAD
®
. See OVERLOAD
Change bag. See vacuum cleaner Use &
Care Guide.
Clear airflow passages.
Clean/change filters. See vacuum cleaner Use
& Care Guide.
Adjust setting.
Adjust control. See vacuum cleaner Use &
Care Guide.
Replace hose.
Change brushroll.
See BELT CHANGING AND BRUSHROLL
CLEANING. (page 10-12)
See BELT CHANGING AND BRUSHROLL
CLEANING. (page 10-12)
Close and latch hood.
Remove any items that may be caught or
jammed, then restart. If vacuum cleaner starts
and stops again, clean brushroll and end
caps, then restart.
Check connections, reconnect hose ends.
Remove any items that may be caught or
jammed, then restart. If vacuum cleaner starts
and stops again, clean brushroll and end
caps, then restart.
See THERMAL PROTECTOR in vacuum cleaner
Use & Care Guide.
- 13 -
SOLUTION