PowerMate
unplugged.
Worn or broken belt.
®
PowerMate
will
Dirty brushroll or end caps.
not run when
attached.
Tripped overload protector in
PowerMate
PROTECTOR (page 9).
Handle switch set to FLOOR
position.
Vacuum cleaner
Wrong pile height setting.
picks up
moveable rugs
®
Suction too strong.
-or- PowerMate
pushes too hard.
TROUBLESHOOTING
®
connections
®
. See OVERLOAD
- 14 -
Plug in firmly.
See BELT CHANGING AND BRUSHROLL
CLEANING (page 10-12).
See BELT CHANGING AND BRUSHROLL
CLEANING (page 10-12).
Remove any items that may be caught or
jammed, then restart. If vacuum cleaner starts
and stops again, clean brushroll and end
caps, then restart.
Slide handle switch to CARPET position to
®
activate PowerMate
Adjust setting.
Slide the electronic suction control to a lower
power setting.
.