Beko TAM 6201 Manual Del Usuario página 9

3 Operation
3.1 Preparation
1. Remove all packaging and sticker materials and
dispose of them according to the applicable
local regulations.
2. Before using the appliance for the first time,
clean the appliance (See the "Cleaning and
care" section).
3. Make sure that the appliance is in an upright
position and on a stable, flat, clean, dry and
nonslip surface.
When using the appliance for the
first time, smoke can develop due
to production residues. However,
this does not mean the appliance
C
is defective. The first time you
switch it on use the appliance as you
normally would but without bread. It
is recommended to use the medium
setting of the browning control (3).
Ensure for proper room ventilation.
3.2 Toasting
1. Connect the power plug into the wall socket.
2. Insert only one slice of bread in each of the two
bread slots (1).
3. Using the browning control (3) select the
desired degree of browning between 1 and 7.
C
Pushing 1 from the browning control
(3) will give the lightest degree of
browning and pushing 7 the darkest.
C
The browning degree can vary
depending on the type of bread.
When toasting several slices of
bread consecutively, the toaster will
C
become hotter and therefore the
bread will gradually become darker.
Therefore select an appropriate
browning degree.
8 / 81 EN
The browing degree of one slice is
C
darker than two slices, although
the browning control (3)is set to the
same level.
4. Press the start lever (2) until it automatically
snaps into place.
– The toasting process begins. The indicator
light of the stop button (6) and the button
of the browning control level (3) illuminates
during the toasting process.
C
If the power plug is not connected
to the wall socket, the start lever (2)
does not snap into place.
C
The degree of browning can also be
adjusted during the toasting process
with the browning control (3).
5. The appliance automatically switches off as
soon as the set degree of browning has been
reached.
– The start lever (2) springs back up and the
stop button (6) light goes off. The toast slices
are pushed upwards and can be taken out of
the toaster.
To cancel the toasting process
C
before it has finished, press the
stop button (6). The start lever (2)
springs back up and the toast slices
can be taken out of the toaster.
After the start lever (2) springs
C
back up, you can use the high-lift
function by pushing the start lever
(2) upwards.
WARNING: Be very careful when
A
taking the toast slices out of the
toaster as the metal parts of the
toaster and also the bread can
become very hot.
Toaster / User Manual