Adjusting The Motor Speed In The Half-Throttle Position - eder 1800 Manual De Instrucciones

900012 Rev. 01 | 09.2017
Adjusting the motor speed in the half-throttle
position
If the motor speed is too high when in the half-throttle position, you
can adjust this. The motor speed when in the half-throttle position
has been optimally set in the factory and it is not usually necessary to
change this.
In order to adjust the motor speed in the half-throttle position:
›
Release the grub screw on the control lever.
›
To do so use a suitable tool, such as an Allen key.
›
In order to reduce the motor speed in the half-throttle position, turn
the eccentric with half-throttle pin anticlockwise.
›
In order to increase the motor speed in the half-throttle position,
turn the eccentric with half-throttle pin clockwise.
›
To do so use a suitable tool, such as a screwdriver.
›
Retighten the grub screw on the control lever.
Commissioning and operation
Capstan winch 1800, 1200, 400 83