Publicidad
Idiomas disponibles
Idiomas disponibles
Occupation of the DIP-switches:
Setting the DMX-
starting address:
Projector number
& channels
Projector 1 - channels 1-4
Projector 2 - channels 5-8
Projector 3 - channels 9-12
Projector 4 - channels 13-16
Projector 5 - channels 17-20
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
In general, lighting effects should not be connected to dimming-packs.
OPERATION
After you connected the effect to the mains, the TB-3 starts running. During the Reset, the motors are
trimmed and the device is ready for use within approximately 20 seconds.
Sound-control/Master/Slave-operation
The lamp is automatically ignited as soon as the condensor microphone receives music signals. If the
projector does not react to the music signals, the microphone sensitivity is too low. You can adjust the
sensitivity with the rotary-control on the rearpanel.
You can do without a controller as the TB-3 features a built-in microphone, which provides automatic sound
control.
If you have connected a footswitch to the Blackout-socket, you can lock the light output (Blackout-mode) and
turn it on again.
Please note: If you wish to change from one operating mode into another, you either have to switch off the
lamp/activate Blackout-mode or unplug the projector from the mains and plug it again.
DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. In order to call up the different features, you first have to ignite the lamp
(control channel 4, DMX-value 6-63).
All manuals and user guides at all-guides.com
1
DIP-switch no.
1
Starting address
On
Off
Off
On
Off
On
Off
On
Off
On
Off
International
L
N
2
3
4
5
6
2
4
8
16
32
22
7
8
9
64 128 256
Publicidad
