HAMPTON BAY 140 081 Manual Del Propietário página 6

Hanging the Fan
REMEMBER
to turn
er. Follow the steps below to hang your
fan properly.
NOTE: This ceiling fan is supplied with two
types of hanging assemblies; the standard
ceiling installation using the downrod with
ball and socket mounting, and the "close-to-
ceiling" mounting. The "close-to-ceiling"
mounting is recommended in rooms with
less than 8-foot ceilings or in areas where
additional space is desired from the floor
to the fan blades. When using standard
downrod installation, the distance from the
ceiling to the bottom of the fan blades will be
approximately 15 inches. The "close-to-ceiling"
installation reduces the distance from the
ceiling to the bottom of the fan blades to
approximately 9 inches.
Once you have decided which ceiling
installation you will use, proceed with the
following instructions. Where necessary,
each section of the instructions will note the
WHEN MOUNTING THE FAN ON A SLOPED
CEILING, THE STANDARD BALL/DOWNROD
MOUNTING METHOD MUST BE USED. THE
MOUNTING PLATE MUST BE MOUNTED SO
THAT THE SLOT OPENINGS ARE ON THE
LOWER SIDE BY SLIDING THE MOUNTING
PLATE FROM THE TOP DOWN. FOR A GREATER
MOUNTING ANGLE, REMOVE THE DECORATIVE
CANOPY BOTTOM COVER (FIGURE 8).
4.
different procedures to follow for the two
types of installation.
off the pow-
Standard Ceiling Mounting
1. Remove the canopy ring from the canopy
by turning the ring to the right until it
unlocks (Figure 5).
2. Remove the mounting plate from the canopy
by loosening the four screws on the top of
the canopy. Remove the two non-slotted
screws and loosen the slotted screws. This
will enable you to remove the mounting
plate (Figure 6).
UL Listed
Outlet Box
Slide Mounting
Plate Over
Screw Heads
120V Wires
Motor Wires
Ball/Downrod
Assembly
Canopy
Canopy
Ring
Figure 5
Motor
Collar
Cover
Hanger
Pin
Motor
Collar
3. Route the wires exiting the top of the
fan motor through the decorative mo-
tor collar cover then the canopy ring.
Make sure the slot openings are on top.
Route the wires through the canopy and
Figure 6
then through the ball/downrod assembly
(Figure 7).
Mounting
Screws
(Supplied With
Outlet Box)
Hook
Ceiling
Mounting
Plate
Pin in
Locked
Position
Locking
Pin
Tighten
Screws
Figure 7