Publicidad
Idiomas disponibles
Idiomas disponibles
Installing Fan to
the Outlet Box
WHEN MOUNTING THE FAN ON A SLOPED
CEILING, THE STANDARD BALL/DOWNROD
MOUNTING METHOD MUST BE USED. THE
MOUNTING PLATE MUST BE MOUNTED SO
THAT THE SLOT OPENINGS ARE ON THE
LOWER SIDE BY SLIDING THE MOUNTING
PLATE FROM THE TOP DOWN.
1. Pass the 120-volt supply wires through the
center hole in the ceiling mounting plate as
shown in Figure 7.
2. Install the ceiling mounting plate on the
outlet box by sliding the mounting plate
over the two screws provided with the
outlet box (Figure 7). When using close-
to-ceiling mounting, it is important that the
mounting plate be level. If necessary, use
leveling washers (not included) between the
mounting plate and the outlet box. Note that
the flat side of the mounting plate is toward
the outlet box (Figure 7).
3. Securely tighten the two mounting screws.
4. Carefully lift the assembly up to the
ceiling mounting plate. If using close-
to-ceiling mounting, hang the fan on the
hook provided by utilizing one of the
holes at the outer rim of the ceiling canopy
(Figure 11). If using standard mounting,
6.
seat the hanger ball in the mounting
plate socket. Make sure the tab on the
mounting plate socket is properly seated in
the groove in the hanger ball (Figure 11).
THE HOOK AS SHOWN IN FIGURE 11 IS ONLY
TO BALANCE FAN WHILE ATTACHING WIRING.
FAILURE TO HANG AS SHOWN IN FIGURE 11
MAY RESULT IN HOOK BREAKING, CAUSING
THE FAN TO FALL. HOOK MUST PASS FROM
INSIDE TO OUTSIDE OF CANOPY.
WHEN USING THE STANDARD BALL/DOWN-
ROD MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING BRACKET MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
Making the Electrical
Connections
REMEMBER to disconnect the power. If
you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below or follow the instructions
included along with the remote control to connect
the fan to your household wiring. Use the wire
connecting nuts supplied with your fan. Se-
cure the connectors with electrical tape.
Make sure there are no loose strands or
connections (Figure 12).
1. Insert the receiver into the ceiling mounting
plate with the flat side of the receiver facing
Figure 11
the ceiling.
2. Connect both green wires from the down-
rod and mounting plate to the bare copper
(Ground) from the outlet box
3. Connect the black wire (AC IN L) from
the receiver unit to the black wire from the
outlet box.
4. Connect the white wire (AC IN N) from
the receiver unit to the white wire from the
outlet box.
5. Connect the white wire (To Motor N) from
the receiver unit to the white wire from the
fan assembly.
Publicidad
