Ryobi RYRM8006 Guía Rápida página 2

CABLE
3x
WARNING:
The cutting deck lift is spring-assisted and under tension.
Serious personal injury can occur if the spring-assisted
deck lift is released suddenly. Always use the deck release
position to secure the deck height adjustment lever in
place while removing or installing the deck. Always keep
hands and fingers below and away from deck lift.
„ Disconnect the power cables that connect the cutting
deck to the mower.
NOTE: The RYRM8006 will have two power cables and
RYRM8007 will have three.
„ Pull the deck release handle out and rotate toward the
back of the mower.
NOTE: To release tension on the quick release handle,
it may be necessary to pull up on the front of the deck
while pulling the handle back. You may also place a 3 in.
high block of wood under the middle of the front edge
of the deck to release the tension. See Figure 2, A and
B for hand placement.
„ Repeat on the opposite side of the mower.
„ Lift the deck and slide forward to detach the deck clip
from the J-hook.
„ Slide the deck out from under the mower.
„ Reverse the process to reattach the cutting deck to the
mower.
NOTE: Reconnect two power cables for the RYRM8006
and three for the RYRM8007.
TTI OUTDOOR POWER EQUIPMENT, INC.
P.O. Box 1288, Anderson, SC 29622, USA
1-800-525-2579 • www.ryobitools.com
999000241
3-2-23 (REV:01)
MAINTENANCE
Fig. 1, RYRM8007
2 — English
J-HOOK
A
J-HOOK
A
1
DECK
RELEASE
HANDLE
2
3
B
Fig. 2, RYRM8006
1
DECK
RELEASE
HANDLE
2
3
B
Fig. 2, RYRM8007
Fig. 3