Celexon INF200 Manual De Usuario página 15

GENERAL NOTES
• If the projection screen fabric does not have a satisfactory flatness, correct
this by loosening the Velcro strips and repositioning the projection the
fabric accordingly. Depending on the temperature, the surface of the fra-
me may be larger than the projection screen surface. In this case, slightly
compress the frame to allow the velcro strips to reach it. Wrinkles in the
projection surface usually disappear by themselves after a short time.
• After unpacking or long storage, wrinkles are sometimes unavoidable with
this type of product. Placing the projection screen in a sunny (warm area)
supports and accelerates this process. If possible, set up the screen 1-2
hours before you actually use it. Any creases should disappear or diminish
considerably in a warm environment.
• During viewing from a normal distance of a few metres, these creases do
not disturb the projection. This type of product is only suitable to a limi-
ted extent for use with short-distance or especially ultra-short distance
projectors. Typically with this technology, this type of projector requires
a perfectly flat surface in order to get a distortion free image which is not
possible with this frame.
• Open the zip a little when the screen is fully erected to relieve the motor
fan.
• Store the screen in a dry and cool environment. If the screen becomes wet
during use, allow it to dry completely before disassembling and storing.
3