Celexon INF200 Manual De Usuario página 18

INSTALLATION
STEP 1:
Lay and spread out the frame of the screen (A) on a flat surface. Make sure
that the front is facing upwards (Velcro upwards) and that the zip on the lower
frame piece is closed.
STEP 2:
Spread out the projection screen fabric (B) and hold it with a second person
at the outer corners. Start at the two upper corners and place the projection
screen fabric on the velcro surface of the frame. The velcro on the frame is
deliberately made a little larger than the velcro on the fabric, This allows for
optimal tensioning and flatness of the fabric for later use.
Align the fabric so that the two corners
of the upper long side of the fabric can
be attached to the velcro inside of the
frame (Fig. 1). Then connect the midd-
le section of the upper long side of the
fabric to the Velcro of the frame. Guide
the fabric as close as possible to the
outer edges of the Velcro on the frame.
Depending on the temperature, the fabric can shrink and the gap between the
frame and the projection surface may vary, which can make installation more
difficult.
Fig. 1: Velcro strip
Projection screen fabric and
frame
6