Auping Aureo Manual Del Usuario página 11

Replacing the halogen bulb
• Turn off the power.
• Remove the lampshade (fig. 12).
• Remove the protective glass from the lamp
socket (fig. 13).
• Remove the bulb from the fitting.
• Use a 10 Watt/12 Volt (type G4) halogen
bulb.
• Do not touch the bulb with your fingers.
• Push the bulb into the fitting, using the pro-
tective covering (fig. 14).
• Remove the covering.
• Replace the protective glass and the lamps-
hade.
• Put the plug into the socket.
Pag 19
fig. 12
Pag 19
fig. 14
2764 BinnenW.pdf - pag.9
Replacing the floor light
• Turn off the power.
• Pull the plastic end out of the lamp stem (fig.
15).
• Separate the plastic halves (fig. 16).
• Remove the bulb from the bayonet fitting
(fig. 17).
• Use a 24V 2W/4W bulb.
• Place the new bulb into the bayonet fitting.
• Replace the plastic halves on the fitting.
• Push the wires back into the lamp stem (fig.
18).
• Put the whole fitting back into the lamp
stem.
If the continuously burning floor night light
disturbs you during the night, the bulb may be
removed.
fig. 13
LET OP !!! Lage resolutie!
Pag 21
fig. 15
fig. 17
fig. 16
Pag 21
fig. 18
GB9
April 12, 2007