Klarstein WONDERWALL SMART 600 Manual De Instrucciones página 18

EN
18
WALL MOUNTING INSTRUCTIONS
Remove the 4 metal wall brackets and
the 4 metal screws for the wall brackets
from the bracket and attach these
brackets to the back of the unit.
Mark the positions of the four holes to
be drilled on the wall, and Drill the holes
with the drill bit. Make sure the distance
between each holes is same as the round
holes on the brackets at back of the
heater.
Insert the plastic rails fitting into the
holes.
Insert the metal screws into the plastic
rails.
Lift the heater, align the four round
holes on the brackets on the back of the
heater with the four screws on the wall,
and slide the screw from position A to
position B by moving the heater slightly.