Step 19
Optional Hidden Wireless Qi Compatible Charger by Eggtronic (sold separately)
å
Insert the HIDDEN WIRELESS Qi COMPATIBLE CHARGER by
EGGTRONIC into one of the large holes in the TOP (A).
å
Use the two SCREWS included with the CHARGER to secure it into
the TOP (A).
å
NOTE: There are no pre-drilled holes in the large holes in the TOP
for the CHARGER. The sides of the CHARGER will expand into the
sides of the large hole as you tighten the SCREWS.
å
Peel the backing from a CORD CLIP (18) and stick the CORD CLIP
to the TOP (A) as shown.
å
NOTE: The CORD CLIP is used to hold the cord against the TOP.
1
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
"Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device".
OR
"Changes or modifications not expressly approved by Sauder Woodworking Co. could void the user's authority to operate this device".
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
431249
A
2
18
www.sauder.com/service
WARNING
Please use the wireless charging port
correctly and safely. Improper use can
cause safety hazards, or damage to your
furniture or household items. Carefully
read the following safety information.
• AVOID dropping
• NEVER use in or near water
• DO NOT disassemble
• DO NOT expose to liquids
• DO NOT use with an extension cord
For safest and fastest charge, only use
original or certified cables.
2
1
Page 25