Sauder Cannery Bridge Serie Instrucciones De Montaje página 36

Step 30 Step
å
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
mounting screw is against the stops as shown in the
right diagram. If it isn't, loosen the adjusting screw and
mounting screw to slide it against the stops. Then tighten
the mounting screw.
å
Fasten the DOOR (W) to the LEFT END (A) as shown in
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
å
Peel the BUMPER from the BUMPER CARD (15) and stick
them onto the DOOR (W) as shown.
å
See the next step for DOOR adjustments.
15
W
A
Page 36 www.sauder.com/service
17
Stop
Mounting
screw
Adjusting
screw
Hinge
429510