Sauder Briarbrook Serie Instrucciones De Montaje página 10

Step 5
å
Fasten the MOLDINGS (K) to the TOP (A). Tighten two
1-9/16" HEX HEAD SCREWS (9) using the L-WRENCH (5).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
5
This hole must be here.
Page 10
1-9/16" HEX HEAD SCREW
(2 used in this step)
K
Meet Part (A). This component has
been engineered to be lighter, stronger,
faster... well ok. Not technically faster.
But definitely makes for a sturdier
Library Hutch that' s easier to assemble
and friendlier to the environment.
www.sauder.com/service
9
K
A
This hole must be here.
430076