Sauder Briarbrook Serie Instrucciones De Montaje página 11

Step 6
å
NOTE: Use the hole locations of your choice for the ADJUSTABLE SHELF (B).
å
Fasten the FRAMES (H) to the ADJUSTABLE SHELF (B), ENDS (D and F), and
MOLDINGS (K) as shown. Tighten sixteen 1/2" HEX HEAD SCREWS (10) using
the L-WRENCH (5).
å
NOTE: You should start each SCREW a few turns before completely tightening
any of them.
1/2" HEX HEAD SCREW
(16 used in this step)
F
These holes must be here.
430076
5
10
H
www.sauder.com/service
This hole must be here.
K
K
B
D
Part (B). Another
sturdier, easier,
friendlier component!
H
Page 11