Sauder Briarbrook Serie Instrucciones De Montaje página 17

Step 12
å
1 - With your pencil, strike a mark through the center of the hole in the SAFETY STRAP just below
st
the top surface of your unit so the SAFETY STRAP will not be visible.
å
2 - Drill a 3/8" hole on the mark.
nd
å
3 - While you squeeze the wings together, gently tap the WALL ANCHOR from the FURNITURE
rd
TIPPING RESTRAINT KIT (96) into the hole until it is even with the surface of the wall.
å
4 - Turn the LONG SCREW through the hole in the SAFETY STRAP and into the WALL ANCHOR.
th
å
NOTE: You will need to turn the LONG SCREW multiple turns to completely tighten and secure
your unit to the wall.
Squeeze the wings
together and tap the
wall anchor into the
3/8" hole in the wall.
430076
Mark and drill
a 3/8" hole
into the wall.
3
rd
4
th
1
st
96
www.sauder.com/service
Electric drill with 3/8" bit
2
nd
Page 17