Sauder Steel River Serie Instrucciones De Montaje página 11

Step 5
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the EXTENSION BLOCKS (F). Use twelve 1/2" FLAT HEAD SCREWS (21).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the EXTENSION BLOCK. Turn
a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
Closed end
Closed end
427849
1
1
1
F
F
F
www.sauder.com/service
21
1
1
2
Push the black lever in and
pull the SLIDE from the RAIL.
21
1/2" FLAT HEAD SCREW
(12 used in this step)
1
1
F
F
F
7
Page 11