Sauder Clifford Place Serie Instrucciones De Montaje página 22

Step 17
1
M
P
Groove
å
Fasten the DRAWER SIDES (K and M) and DRAWER
BRACE (O) to the DRAWER FRONT (P). Tighten six
HIDDEN CAMS.
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
å
Fasten the DRAWER BACK (L) to the DRAWER SIDES (K and M) and DRAWER BRACE (O). Use six
BLACK 1-1/2" FLAT HEAD SCREWS (17).
å
NOTE: Be sure the DRAWER BOTTOM (N) inserts into the groove of the DRAWER BACK (L).
Page 22
1
Surface with
HIDDEN CAMS
O
K
L
M
www.sauder.com/service
2
M
å
Slide the DRAWER BOTTOM (N) into the grooves in the
DRAWER SIDES (K and M) and DRAWER FRONT (P).
O
N
K
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n fi
n i s h
s u r
e d
f a c
e
N
P
Start each screw a few turns before
completely tightening any of them.
17
BLACK 1-1/2" FLAT HEAD SCREW
(6 used in this step)
K
433360