Sauder Clifford Place Serie Instrucciones De Montaje página 25

Step 20
å
Push the RUBBER SLEEVES (16) over the METAL PINS (15).
Insert the METAL PINS into the hole locations of your choice in
the ENDS (A and B). Set the ADJUSTABLE SHELF (G) onto the
METAL PINS.
å
Fasten the HINGES on the RIGHT DOOR (R) to the HINGE
BRACKETS on the RIGHT END (A).
å
Follow the enlarged diagram below fastening both HINGES to
the HINGE BRACKETS keeping the DOOR vertical at all times.
å
Tighten the mounting screws in the HINGE BRACKETS.
å
Repeat this step for the LEFT DOOR (Q).
B
433360
G
Q
This screw will fit
into this slot. Then
tighten the screw.
www.sauder.com/service
Mounting screw
(4 used)
16
A
R
The screw on the back
side of the HINGE will
fit into this slot.
15
Page 25