Publicidad
Step 6
å
First, slide the UPRIGHT MOLDING (J) onto the notched edge
of the UPRIGHT (P).
å
Then, fasten the EXTENSION BLOCK (S) to the UPRIGHT (P).
Use three SILVER 1-1/8" FLAT HEAD SCREWS (10S).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
å
NOTE: Do not overtighten the SCREWS into the UPRIGHT.
Slide the UPRIGHT
MOLDING (J) onto
the notched edge.
www.sauder.com/service
J
Notched edge
P
S
427018
The groove
is closer to
this edge.
10S
SILVER 1-1/8" FLAT HEAD SCREW
(3 used in this step)
Surface with more holes
Page 11
Publicidad
