Publicidad
Step 4
å
NOTE: You have the option to fasten the RAILS to one of three sets of holes as shown. Measure your component that
will be sitting on the SLIDING SHELF and the distance from the RAIL screw hole to the top of the END to be sure the
component will fit in your unit.
å
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (35MA) to the RIGHT END (A2) and UPRIGHT (P). Use four GOLD 5/16" FLAT HEAD
SCREWS (3S) through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END and UPRIGHT. Turn a
SCREW into this hole.
å
NOTE: The EXTENSION SLIDES (35MC) will be used later for the SLIDING SHELF.
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Open end
Optional RAIL holes
www.sauder.com/service
35MC
3S
3
2
1
P
Edge with
WOOD DOWELS
2
3
A2
427018
35MA
Open end
1
Optional RAIL holes
7
Page 9
Publicidad
