Publicidad
Step 13
å
Carefully lay your unit onto its front edges. We have provided a Nail Holder tool to use in this step for proper positioning of
the NAILS. Please refer to the parts of the Nail Holder as the bead, offset edge, and nail slot as shown in the diagram below.
å
Diagram 1. Place the BACK (O) into the lower edges of the ENDS (A2 and B2) with the top edge of the BACK (O) against
the bottom surface of the TOP (N).
å
Diagram 2. Place the OFFSET edge of the Nail Holder against the bottom edge the BACK (O) and 1-1/2" in from the
corner near the LEFT END (B2). Place a NAIL (1N) into the nail slot of the Nail Holder. Tap the NAIL through the BACK and
into edge of the BOTTOM (K). Remove the Nail Holder from the NAIL and completely tap the NAIL in with your hammer.
Finish fastening the BACK to the BOTTOM with the hammer and Nail Holder evenly placing eight NAILS along the bottom
edge. Fasten eight NAILS (1N) along the top edge of the BACK (O) using the BEAD edge of the Nail Holder.
å
Diagram 3 and 4. To fasten the remaining two side edges of the BACK (O), place the BEAD edge of the Nail Holder down
and use four NAILS (1N) evenly spaced along each side.
Offset edge
Nail
Holder
Bead
NAIL
(24 used in this step)
4.
Bead
Page 18
Nail slot
1N
N
A2
O
K
Lower edge
1.
427018
Bead
B2
2.
1-1/2"
Offset edge
www.sauder.com/service
3.
Bead
Publicidad
