Sauder OFFICE WORKS AFFIRM Serie Instrucciones De Montaje página 6

Step 1
å
Assemble your unit on a carpeted floor or on the empty carton to avoid scratching your unit or the floor.
å
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten two EXTENSION RAILS (35MA) to the RIGHT END (A). Use four GOLD 5/16" FLAT HEAD SCREWS (3S) through
holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END. Turn a SCREW into this
hole.
å
NOTE: The EXTENSION SLIDES (35MC) will be used later for the DRAWERS.
Push the black lever in and pull the SLIDE from the RAIL.
Page 6
Look for this icon. It means a video assembly tip is
available at www.sauder.com/service/tips
Find the numbered video or scan the QR code.
35MC
2
3
A
427874
35MA
Open end
1
1
2
3
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
www.sauder.com/commercial-office/service
7
Open end
3S