Sauder OFFICE WORKS AFFIRM Serie Instrucciones De Montaje página 20

Step 14
1
D576
Groove
å
Insert the DRAWER SIDES (D576 and D577) at an
angle into the slot at each end of the UPPER
DRAWER FRONT (J).
3
M67
1
M67
Surface with
HIDDEN CAM
å
Push one HIDDEN CAM (1F) into the DRAWER
BRACE (M67). Then, insert the metal end of a CAM
DOWEL (2F) into the HIDDEN CAM.
å
Fasten the DRAWER BRACE (M67) to the UPPER
DRAWER FRONT (J). Tighten one HIDDEN CAM.
Page 20
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
J
D577
Arrow
Metal end
1F
2F
Hidden part using
recycled material.
Color may vary.
J
2
D576
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (B60) into the grooves
in the DRAWER SIDES (D576 and D577) and UPPER
DRAWER FRONT (J).
4
D576
M67
å
Fasten the DRAWER BACK (D578) to the DRAWER
SIDES (D576 and D577) and DRAWER BRACE (M67).
Use five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
427874
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
B60
U n fi
n i s h
s u r
e d
f a c
e
J
D577
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(5 used in this step)
D578
D577
www.sauder.com/commercial-office/service
9
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.