Sauder Rollingwood Serie Instrucciones De Montaje página 26

Step 21
å
Carefully turn your unit over onto its front edges. Unfold
the BACK (C) and lay it over your unit.
å
Make the bottom edge of the BACK (C) even with the
bottom surface of the BOTTOM (B). Then, make equal
margins along the side edges of the BACK (C). Push on
opposite corners of your unit if needed to make it "square".
å
Fasten the BACK (C) to your unit using the NAILS (17).
Notch
Page 26
C
www.sauder.com/service
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
17
NAIL
(20 used in this step)
B
8
431439