Sauder Portage Park Serie Instrucciones De Montaje página 24

Step 18
å
Carefully stand the LARGE TOP assembly upright.
å
Fasten the CONNECTOR (FF) to the LARGE TOP (A). Tighten five
1" HEX HEAD SCREWS (16) using the L-WRENCH (12).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
å
Insert a GROMMET WITH CAP (11) into each large hole in the
LARGE TOP (A).
Drawers on the LEFT
Page 24
FF
1" HEX HEAD SCREW
(5 used in this step)
12
www.sauder.com/service
A
16
A
11
FF
Drawers on the RIGHT
427478