Bosch GLI 10,8 V-LI Professional Manual Original página 14

All manuals and user guides at all-guides.com
OBJ_BUCH-1072-004.book Page 14 Thursday, November 29, 2012 1:44 PM
14 | English
Technical Data
Cordless Worklight
Article number
Rated voltage
Lighting duration, approx.
Operating temperature
Storage temperature
Weight according to EPTA-Procedure 01/2003
Assembly
Battery Charging (Accessory) (see figure A)
 Use only the battery chargers listed on the accessories page. Only these bat-
tery chargers are matched to the lithium ion battery of your cordless worklight.
Note: The battery is supplied partially charged. To ensure full capacity of the battery,
completely charge the battery in the battery charger before using your power tool for
the first time.
The Lithium-Ion battery can be charged at any time without reducing its service life.
Interrupting the charging procedure does not damage the battery.
The lithium ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the cordless worklight is switched off
by means of a protective circuit.
 Do not continue to press the On/Off switch after the cordless worklight has
been automatically switched off. The battery can be damaged.
To remove the battery 3, press the battery unlocking button 4 and pull the battery out
of the cordless worklight toward the rear. Do not exert any force.
The battery is equipped with a NTC temperature control which allows charging only
within a temperature range of between 0 °C and 45 °C. A long battery service life is
achieved in this manner.
Observe the notes for disposal.
1 609 92A 00A | (29.11.12)
GLI 10,8 V-LI
3 601 D37 U..
V= 10.8
min/Ah 350
°C –10...+40
°C –15...+50
kg 0.3
Bosch Power Tools