Urmet 1092/679 Guía Rápida página 12

2.2 OPENING THE BOX
Check that the packing and the contents are not visibly damaged. Contact the retailer immediately if parts are either
missing or damaged. Do not attempt to use the device in this case. Send the product back in its original packing if it is
damaged.
2.2.1 CONTENTS OF THE BOX
 N°1 Easy Dome 20X with IR LED
 N° 1 Power supply
 N° 1 Wall bracket
 N°1 User manual
IMPORTANT NOTE
Accessories may be changed without prior notice.
3 IMPORTANT SAFETY NOTES
The following important notes must be followed carefully to work the Ref.1092/679 camera and respective accessories in
total safety.
The term "video system" here means a camera and all components needed for its operation (e.g., power, leads,
supports, control board and more).
Read the instructions
Read all safety rules and instructions carefully before starting to work the video system.
Keep the instructions
Keep the safety notes and instructions for use for future reference.
Respect the warnings
Pay attention to all warnings on the camera and in the instruction manual.
Follow the instructions
Follow the instructions in the instruction manual to the letter.
Cleaning
Disconnect all electrical parts from the mains before cleaning.
Attachments
Do not use attachments other than those recommended in the instruction manual because this could cause risks for the
products.
Accessories
Do not position the camera on unsteady trolleys, stands, brackets or tables. The camera could fall and severely injury
adults and children in addition to seriously damaging the product. Follow the instruction manual and only use the
recommended accessories for the camera for installation and set-up.
Ventilation
Never position the camera near or over radiators or sources of heat. Check that the area is suitably ventilated before
installing the camera inside partially closed areas (such as recesses, bookshelves and shelves). Refer to the instructions
shown in the installation manual.
Electrical power
A switch for performing maintenance operations on the camera must be included.
Connect the camera only to the electrical power supply shown on the ratings plate. Contact your retailer if in doubt.
Power lead protection
Lay the power wires keeping them from being trodden on or squeezed by objects placed on top of them. Pay particular
attention to leads near plugs, screws and the product outlet.
Lightening
Disconnect the power lead and the wiring to protect the camera during electrical storms or when it is left unattended and
not used for a long time. This will prevent damage to the video system in the event of lightening or electrical line
overload.
12
DS1092-233D