Urmet 1092/679 Guía Rápida página 14

4 INSTALLATION PROCEDURE
This section contain detailed instructions for installing Urmet Domus 1092/679. These instructions assume that the
installer has a good knowledge of installation techniques and is capable of adopting safe installation methods.
4.1 EASY DOME MINIMUM CONFIGURATION
The Easy Dome camera contains a built-in receiver that decodes the controls from the control keypad. At least one
keypad is therefore needed to control the camera. In addition to configuring operating parameters, the keypad is used to
manage horizontal axis (360° continuous) and vertical axis (180°) panning and tilting, motorised zooming, recalling and
programming the Easy Dome preset sequences.
The following sections show how to use these adapters.
 Please check a 120 Ω resistor is mounted on both RS-485 terminals.
4.1.1 WALL INSTALLATION
Identify the camera installation point and proceed as follows:
 Include a connection box for making connections and fitting the power unit, if required.
 Drill holes according to the type of wall (cement, wood, etc.) and the fastening devices used.
 If the type of installation includes laying of cables in sight, unscrew the plug on the lower part of the bracket with
a slot type screwdriver and insert all the functioning cable of the dome inside the bracket, providing a suitable
protection conduit for the cables.
 Insert the connection cables (power-video-data) inside of the bracket until they exit from the opposite side.
 Fasten the bracket to the dome screwing the 3 screws at the end of the bracket
 Fasten the bracket to the wall.
 Open the metal cover inside the plastic housing to find the configuration switch.
14
DS1092-233D