IKEA BOLLSIDAN Manual Del Usuario página 3

English
This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall not be made by
children without supervision.
Advice and instructions for BOLLSIDAN.
Sound level:
Lower than 55 dB(A).
Height setting interval:
72-117 cm/28.3-46.1 inch
Maximum load:
60kg/132lbs.
Temperature interval at usage:
+32 up to +104 °F/+0 °C up to + 40 °C.
Temperature interval at storage:
+14 up to 104°F/-10°C up to 40°C.
Humidity:
20% up to 80% at 104°F/40°C.
Power supply unit:
DC 29 V, 130 W.
Model:
W52RA628-290018
This appliance shall only be used together with the
included power supply unit.
Every person who is responsible for this table at
installation or employment of the table in daily use or
in service and repair work should carefully read these
instructions. Keep these instructions close to your sit/
stand table.
Installation instructions
The table is assembled according to separate
assembly instructions.
Connect the cable from motor to power supply and
hand control. Place the electrical cables so that they
do not get damaged, see assembly instruction.
Connect the electrical cable to a wall socket.
NOTE! The electrical cable must have full mobility.
The table is now ready for use. The motors stop
automatically when the table reaches its lowest and
highest position respectively.
Usage of the table
The table shall only be used as a working table with
the possibility to continuously adjust working height
between sitting and standing position. The table
shall only be used indoors and in dry premises (office
environment or similar).
The table must not be overloaded - maximum load is
60 kg/132 lbs. The system may be run continuously
for maximum 2 minutes. Afterward, the motors must
stand by for approx. 18 minutes before they can be
used again.
Follow these instructions when adjusting table
height:
1. Make sure no objects are in the way of the table
adjusting height freely.
2. In order to run the table up/down, press the
manoeuvre button up and down respectively or
use your Desk control app.
Safety regulations
• When the table is run up/down, keep the necessary
safety distance to avoid the risk to get squeezed
between the moving table top and fixed objects in
the surrounding area.
• When the table is run up/down the user shall
keep watch so that nobody is injured or no object
is damaged. The table top must not bump into a
fixed object so that the table is overturned. Always
remove any office chair before the table is run up/
down.
• The table tripod must not be altered or
reconstructed in any way. In service and repair
work of the table, the electrical cable must always
be disconnected from the wall socket.
• Modifications to the legs are absolutely forbidden!
• The table must not be used as a hoisting device for
persons.
Maintenance and repair instructions
• After approx. 1 week of use, check that the screws
are properly tightened.
• If the table cannot be lowered or raised, check the
connections between the legs and the wall socket.
3