Publicidad
Idiomas disponibles
Idiomas disponibles
5. Service
a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
b) Always arrange for the replacement of the
plug or the power cord to be carried out by
the manufacturer of the tool or its customer
service department. This will ensure that the
safety of the power tool is maintained.
Appliance-specific safety instructions
■
This appliance may not be used by children
or people with reduced physical, sensory or
mental capabilities or a lack of experience and
knowledge. Do not allow children to use the
appliance as a toy. Cleaning and user mainte-
nance tasks may not be carried out by children.
■
Children should be kept away from this appli-
ance.
■
Avoid using the appliance at temperatures
below 5°C.
■
Do not expose the appliance to rain and do not
submerse it in water.
■
Never leave the appliance unsupervised while it
is in use.
■
Caution! Operate the compressor for short
periods only. The appliance may overheat if
operated for longer than 10 minutes. Switch the
appliance off immediately and allow it to cool
down for at least 10 min.
■
Risk of injury! Do not pump any objects up to
more than the intended pressure. They could
burst and cause injuries and/or material
damage.
■
Never use the appliance for purposes other
than those for which it was designed.
■
Do not use this product if the hose is damaged.
Replace a damaged hose immediately.
■
Do not pull out the hose while inflating as the
high pressure can cause injuries.
■
To avoid risks, do not direct the inflation inlet
towards your body.
CSP 12 A1
■
The appliance must always be kept clean,
dry and free from oil or grease.
■
Never use petrol or other flammable liquids to
clean the appliance! Vapours remaining in the
appliance can be ignited by sparks and cause
the appliance to explode.
■
Remain alert at all times! Do not use the appli-
ance if you are distracted or feeling unwell.
■
Before use, check the cigarette lighter to make
sure there is no rust or residue in it. If the cigarette
lighter socket has poor electrical conductivity,
this may cause the product or the power source
to overheat, resulting in damage to the product.
Before use
♦
Pick up and carry the appliance using the
carrying handle
♦
Plug the 12 V vehicle connector plug
suitable socket in your vehicle. The display
lights up and the appliance is ready for use.
Operation
NOTE
►
The appliance vibrates during operation.
Therefore, always put it down during opera-
tion. There are four feet
the appliance for this purpose.
ATTENTION!
►
This appliance is not designed for continuous
operation. The appliance may be used for a
maximum of 10 minutes continuous operation.
Allow the appliance to cool down completely
and then try using it again.
♦
Select the accessories you need.
♦
Remove the hose
is secured for transport and storage with the
elastic band
.
Display
♦
You can switch between "bar" and "psi" on the
display
by pressing the selection button
.
into a
on the bottom of
from the appliance. This
GB │ IE
│
.
5
■
Publicidad
