Gardena ZoneProtect 15021 Instrucciones De Empleo página 11

Disposal:
(in accordance with RL2012/19/EC / S.I. 2013 No. 3113)
The product must not be disposed of to nor-
mal household waste. It must be disposed
of in line with local environmental regulations.
IMPORTANT!
v Dispose of the product through or via your
municipal recycling collection centre.
Disposal of the battery:
The battery contains lithium-ion cells
that should not be disposed of with
normal household waste at the end
Li-ion
of its life.
IMPORTANT!
The battery may only be removed by qualified per-
sonnel.
1. If you have any questions regarding the removal
of the battery, please contact the GARDENA
Service.
2. Dispose of the batteries through or via your
municipal recycling collection centre.
2. INSTALLATION
Preparation:
• Charge the battery (see 3. OPERATION).
• You can use the accessories of your
robotic lawn mower for the zone cable,
ground hooks and connection clamps.
Alternatively, you can also obtain these
from the GARDENA dealer.
• The robotic lawnmower must not be in
ECO Mode during installation
(see ECO Mode in the Operator's Manual
for the robotic lawnmower).
15021-20.960.01.indd 11 15021-20.960.01.indd 11
• Update the mower's firmware
(via www.gardena.com):
SILENO minimo from 5995762-03
SILENO city from 5908253-11
SILENO life from 5939856-06
• To find out if an update is required, you can
check which firmware is currently installed
on your mower:
SILENO city & SILENO life:
Open the quick info menu (see the
Operator's Manual of the robotic
lawn mower).
SILENO minimo: You will find the infor-
mation in the GARDENA Bluetooth App.
• Enable the Zone Generator function of your
robotic lawn mower menu / app. Refer to
the Operator's Manual of the robotic lawn-
mower.
Conditions for the installation:
• Lay the wire as described in the instructions
for the robotic lawnmower
(chapter: To examine where to put the
boundary wire ).
• The zone must be completely within the
mowing area of the boundary cable
• The distance from the zone wire
(6)
boundary wire must be at least 60 cm.
• The zone should not cover the guide
(7)
wire , otherwise the robotic lawnmower
may not find the charging station. If you
do not remember where the guide wire is,
start the robotic lawnmower at the end
of the guide cable and let it return to the
charging station (see Operator's manual
of the robotic lawnmower).
• The distance from zone wire
(7)
wire should be at least 60 cm.
(6)
.
(2)
to the
(2)
to guide
11
04.02.22 10:43 04.02.22 10:43