MicroPower MTM Serie Instrucciones De Uso página 3

English
English
Battery charger MTM
Operating instructions
General
MTM is a regulated, programmable battery charger. MTM exists in different
versions either for charging freely ventilated or valve regulated lead/acid batteries.
It can also be equipped with a charging curve for Ni-Cd batteries or similar.
The battery charger is supplied with a pre-set charging curve adapted to the
type of battery specified during ordering. The charging curve that is set can be
read on the display by pressing the * key.
There are different versions of MTM for charging batteries with a battery voltage
of 24 V or 120 V and a charging current from 40 A to 300 A.
The built-in microprocessor controls current and voltage during the charging
process. The charging process is displayed with LEDs on the panel of the battery
charger. Charging time and temperature in the battery charger are monitored and
charging is limited in the event of cell defects or during insufficient cooling etc.
During the entire charging process, the battery charger gathers in data and carries
out calculations in order to fully recharge the battery with respect to amount of
discharge, temperature, age and more. The battery charger is cooled by means of a
temperature-regulated fan.
Read through these operating instructions carefully before you begin using
the battery charger. Store the operating instructions so that they are always
available for the person using the battery charger.
3