Publicidad
Idiomas disponibles
Idiomas disponibles
In Winter
Inflation
Low temperature will harden the PVC material and make it more fragile.
●
The new spa might have been stored or transported at a low temperature (below 4°C / 39°F) before it is unfolded. Put the package indoors or
somewhere warm for 12 hours to soften the material before use.
●
The lower the temperature is, the more air the spa tub will require, and the longer the inflation will take. After water is heated to a much higher tempera-
ture, the air inside the chamber will get swollen. To shorten the inflation period, and to reduce the expansion of the spa liner, we suggest inflating the spa
at a temperature higher than 15°C / 59°F. If the ambient temperature is below 0°C / 39°F, the spa should not be inflated.
Heating and Heat Preservation
In cold weather, heating the water up will take much more time. It is suggested to:
●
Fill the spa tub with lukewarm water (not higher than 40°C / 104°F) to get it heated it more quickly.
●
Use ground mat and inflatable bladder (*optional) for better heat preservation effect.
●
When the outdoor temperature is below 4°C(39°F), even when not using the spa, as long as it is filled with water, the heater should always be turned on
(or put the spa in stand-by mode) to prevent water from freezing.
●
Your spa is equipped with an Anti-icing System. Put the spa in stand-by mode, when the water temperature falls below 1°C/33.8°F, the heater runs
automatically until the water is heated up to 3°C/37.4°F. This will help prevent water from freezing. If you are not going to use the spa in near future，
please disassemble the spa and store it following the storage procedure.
In Rainy days
For the spa that is placed outdoors, do not use it when it rains.
If the spa is placed under rain shelter, do not turn on the bubble function. This is because the rain in the nearby air will also be sucked into the pump,
causing the bubble generator to get damp and rusty which could result in malfunction and void your warranty.
It is recommended to put the plug and socket somewhere not exposed to rain to prevent damage caused by water accumulation due to excessive rain.
DISPOSAL AND ENVIRONMENTAL PROTECTION
This marking indicates that the product should not be disposed of with other household waste. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle the product responsibly to promote the sustainable reuse of
material resources. Information on disposal can be obtained from your local authorities.
To return your used device, please use the return and collection systems or contact the retailer where the product was purchased for
environmentally safe recycling.
TROUBLESHOOTING
ERROR CODE CHART
LED READING
Signal wire is loose
- - - / 888 / EEP
Communication failed
Water temperature is below 0°C (32°F) or exceeds 50°C (122°F)
F0
Temperature sensor failure
F1 immediately shows after pressing FILTER , HEATING or UV
F1
F1 shows 15s after pressing FILTER, HEATING or UV
CAUSE
15
SOLUTION
Contact local MSpa Service Center
Contact local MSpa Service Center
Change the water
Contact local MSpa Service Center
Clean the parts and tubes that the water goes through
1. Add more water to the minimum line
2. Clean the parts and tubes that water goes through
3. Contact local MSpa Service Center
Publicidad
