For Wood Countertops:
Mark and pre-drill the wood screw holes at the locations shown on the template.
Waterproof any exposed areas of wood.
For Marble Countertops:
Position the countertop upside down on foam padding to protect the surface. Mark
and drill 3/8" (1cm) holes 5/8" (1.6cm) deep at the locations shown on the template.
Use a setting tool and hammer to secure the anchors.
For All Installations:
If the countertop has not been installed, install it at this time.
Drill the faucet holes according to the faucet installation instructions.
Install the faucet to the countertop according to the manufacturer's instructions.
Install the drain to the lavatory according to the manufacturer's instructions.