ULTIMATE SPEED UMAP 12000 B2 Instrucciones De Funcionamiento Y De Seguridad página 19

lead from the portable jump starter with power bank
10
30 seconds and disconnect firstly the black battery clamp and
then the red clamp from the battery poles. Otherwise, it could
result in dangerous situations! Leave the vehicle engine running.
PLEASE NOTE: The button on the LED box
lead has no effect and must not be used. It is only used for
troubleshooting purposes during the manufacture of the device.
z Charging mobile phones and tablets
„
Press the power switch
„
Connect your mobile phone or tablet's USB power cable to
the USB output (5 V
mobile phone or tablet.
PLEASE NOTE: Charging is not possible if the portable
jump starter
1
z Using the 12 V DC output 8 A with
cigarette lighter adapter
„
Press the power switch
„
Connect the 12 V/8 A cigarette lighter adapter
12 V DC output 8 A
power bank
PLEASE NOTE: You will not be able to use the portable
jump starter with power bank
ATTENTION: Only use the 12 V/8 A cigarette lighter
adapter delivered with your product
circuit if you use third-party adapters.
z Switch on lighting
Light mode
„
When switching on the LED lights
button for 3 seconds.
7
As soon as the vehicle starts, remove the jump
7
/1 A
with power bank is being charged itself.
7
to your portable jump starter with
3
und then connect it to your terminal device.
1
GB/IE/NI/CY/MT
.
/2 A ) and then to your
5 6
.
if it is being charged.
1
. There is a risk of a short
14
, hold down the power
2
within
1
of the jump
11
on the
14
19