CUSTOMER SERVICE AND SPARE PARTS
If the appliance is not functioning properly, check
that:
•
the plug is firmly in the wall socket and the mains
power switch is on;
•
there is an electricity supply (find out by plugging
in another appliance);
•
the thermostat knob is in the correct position.
•
If there are water drops on the bottom of the
cabinet, check that the defrost water drain
INSTALLATION
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply. Voltage
can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
Door reversibility
The appliance is supplied with the door opening to
the right. For door opening in the opposite direction,
perform the following actions prior to installation
Warning! When changing the side at which
the door opens, the appliance may not be
connected to the mains. Remove plug from
the mains beforehand.
1. Unscrew the upper pin and remove the spacer.
2. Remove the door.
3. Unscrew with a key the lower pin and replace it on
the opposite side.
4. Reinsert the door, refit the spacer and rescrew the
upper pin on the opposite side.
Instructions for totally built-in appliances
Building-in instructions
Dimensions of housing
Model IKE 230-2
Height 1225 mm
Depth
550 mm
Width
560 mm
opening is not obstructed (see "Defrosting"
section).
•
If your appliance is still not working properly after
making the above checks, contact the nearest
service centre.
To obtain fast service, it is essential that when you
apply for it you specify the model and serial number
of your appliance which can be found on the
guarantee certificate or on the rating plate located
inside the appliance, on the bottom left-hand side.
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C.
Directives
ATTENTION!
It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation.
50 mm
D567
min.
200 cm
2
min.
200 cm
2
19