Dräger FPS IMD Instrucciones De Uso página 24

en |
Use
Up to 5 charging cradles can be connected together.
1. If required, link the charging cradles together (see Figure C on the fold-out
page)
a. Remove the covers (1, 3).
b. Plug the link (4) into the charging cradle.
c. Plug the link (4) from one charging cradle into the opening in the next
charging cradle.
d. Lock the locking screw on the upper side of the charging cradle and join
two charging cradles with a locking clip (5).
2. Plug the power supply unit or the vehicle adapter (2) into the charging
cradle.
3. If necessary, pre-drill holes and fasten the charging cradles with the screws.
4. Connect the plug-in power supply unit or the vehicle adapter to the power
supply.
4.3 Preparations before each use
1. Fully charge the battery in the In-Mask Display (all the LEDs on the charging
cradle will then light green).
2. Make sure that the FPS Quick Adapter is correctly fitted in the full face mask.
3. Visually inspect the In-Mask Display: There must be no damage present.
4. Lay the In-Mask Display on the adapter in the full face mask. Magnets fix the
In-Mask Display on the adapter.
5. Pairing the thermal imaging camera with the In-Mask Display
(see also Figure B on the fold-out page)
a. Switch on the thermal imaging camera (1) and the In-Mask Display (2).
To do this, press both On/Off buttons for approx. 2 seconds. The startup
screen is shown on the In-Mask Display.
b. Hold the pairing symbol on the thermal imaging camera directly at the
point on the full face mask at which the pairing symbol on the In-Mask
Display is located. The LED on the thermal imaging camera flashes blue.
An icon indicating the status of the pairing process is displayed on the In-
Mask Display.
Once the thermal imaging camera and the In-Mask Display are paired,
the LED lights blue for 5 seconds and the thermal image is displayed on
the In-Mask Display.
6. Check that the thermal image is readily visible. The full face mask must be
put on for this. If necessary, remove the full face mask and snap the optics in
another position.
24
Dräger FPS IMD