Panasonic CS-E18RB4EAW Instrucciones De Funcionamiento página 6

How to use
MODE
To select operation mode
AUTO - For your convenience
• During operation mode selection the POWER
indicator blinks.
• Unit selects operation mode every 10 minutes
according to setting temperature and room
temperature.
HEAT - To enjoy warm air
• Unit takes a while to warm up. The POWER
indicator blinks during this operation.
COOL - To enjoy cool air
• To reduce power consumption during COOL
mode, use curtains to screen off sunlight and
outdoor heat.
DRY - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
POWERFUL/
To switch between
QUIET
powerful & quiet
POWERFUL QUIET
POWERFUL: To reach temperature quickly
POWERFUL
• This operation stops automatically
Single
after 20 minutes.
• Press the button again or turn OFF the
Multi
unit to stop this operation.
QUIET: To enjoy quiet operation
QUIET
• This operation reduces airfl ow noise.
Can be activated in all modes and can be
cancelled by pressing the respective button again.
Auto OFF/ON button
POWER (Green)
TIMER (Orange)
POWERFUL (Orange)
QUIET (Orange)
AUTO
AIR SWING (Orange)
6
NORMAL
Use when remote control is misplaced or a malfunction occurs.
1. Press the button once to use in AUTO mode.
2. Press and hold the button until you hear 1 beep, then release to use in forced
COOL mode.
3. Repeat step 2. Press and hold the button until you hear 2 beeps, then release
to use in normal COOL mode.
4. Repeat step 3. Press and hold the button until you hear 3 beeps, then release
to use in forced HEAT mode.
• Press the button again to turn off.
Control Panel
Remote control
display
AUTO
FAN
SPEED
HEAT
AIR
COOL
SWING
DRY
OFF/ON OFF/ON
MODE
TEMP TEMP
AIR SWING
POWERFUL/
FAN SPEED
QUIET
TIMER TIMER
ON ON SET SET
1 1 2 2 3 3
OFF OFF CANCEL CANCEL
AC
RC
SET CHECK CLOCK CHECK CLOCK RESET
Single split system
Single
Multi split system
Multi
Remote control
receiver
POWER (Green)
TIMER (Orange)
POWERFUL (Orange)
QUIET (Orange)
AUTO
AIR SWING (Orange)
Press and hold for
approximately
10 seconds to show
temperature setting in
°C or °F.
Press to restore the
remote control to
default setting.
Not used in normal
operations.