Publicidad
Idiomas disponibles
Idiomas disponibles
Adjust High/Low Flame Setting Screw
When converting from LP to Natural gas, you will need to
adjust the high flame setting screw for ideal burner flame
height (see page 4).
The flames of the grill burners and side burners (on some
models) should be blue and stable with no excessive noise or
lifting (LP gas flames will have a slightly yellow tip). A yellow
flame indicates not enough air. If flame is noisy or lifts away
from the burner, there is too much air. Some yellow tips on
flames when the burner is set to HIGH setting are acceptable
as long as no carbon or soot deposits appear. The flames
should be approximately
1.
Remove each control knob for the main burners and sear
burner.
1.
Use a flathead screwdriver to turn the high flame set
screw clockwise approximate 90º.
3.
Check that burner operates at the new high flame setting.
It may be necessary to adjust the screw setting slightly
more to get the ideal burner flame height.
2.54 cm / 1 in
high.
2.54 cm / 1 in
4.
Replace the control knobs and turn off the burner.
5.
Repeat steps 2 through 4 for each burner if needed.
6.
Replace the flame tamers and grates after the burners
have been cooled.
Record Conversion
The LP appliance nameplate is located inside the grill
cabinet on the left-hand side. Once converted, place the
NG appliance nameplate as close as possible to the
current LP appliance nameplate without covering it.
In the last page of the Use and Care Guide, write
"Converted to Natural Gas". Also record the conversion
date and the technician/company that performed the
conversion.
14
Publicidad
