Kärcher K 2 Manual Del Usuario página 20

Care and maintenance
DANGER
Risk of electric shock.
 Prior to all work on the appliance,
switch off the appliance and pull the
power plug.
Clean the sieve in the water
connection
Clean the sieve in the water connection
regularly.
 Remove coupling from the water con-
nection.
ATTENTION
The sieve must not be damaged.
Illustration
 Pull the sieve out using flat pliers.
 Clean the sieve under running water.
 Reinsert the sieve into the water con-
nection.
Cleaning the detergent filter
 Remove filter from suction hose for de-
tergent and clean under running water.
20 English
Troubleshooting
You can rectify minor faults yourself with
the help of the following overview.
If in doubt, please consult the authorized
customer service.
DANGER
Risk of electric shock.
 Prior to all work on the appliance,
switch off the appliance and pull the
power plug.
Appliance is not running
 Pull on the lever of the trigger gun; the
device will switch on.
 Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the mains supply.
 Check the mains connection cable for
damages.
Appliance does not start, motor
hums
Voltage reduction due to weak mains sup-
ply or when using an extension cable.
 When switching on, first pull the lever of
the trigger gun and then switch the ap-
pliance switch to "I/ON".
 When switching on, first pull the lever of
the hand spray gun and then switch the
appliance switch to "I/ON" or "eco".
Pressure does not build up in the
appliance
 Check water supply for adequate deliv-
ery rate.
 Pull out the sieve in the water connec-
tion using flat-nose pliers and clean un-
der running water.
 Appliance ventilation: Switch the appli-
ance on with the high-pressure hose
detached and operate (max. 2 minutes)
until the water exits the high-pressure
connection without bubbles. Switch off
appliance and reconnect high-pressure
hose.