Connecting A N1500 Series Switch To A Terminal - Dell N1500 Serie Guía De Introducción

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connecting a N1500 Series Switch to a Terminal

After completing all external connections, connect a serial terminal to
a switch to configure the switch.
NOTE:
Read the Release Notes for this product before proceeding. You can
download the Release Notes from the Dell Support website at dell.com/support.
NOTE:
We recommend that you obtain the most recent version of the user
documentation from the Dell Support website at dell.com/support.
To monitor and configure the switch via serial console, use the console port
on the front panel of the switch (see Figure 1-1 on page 8) to connect it to
a VT100 terminal or to a computer running VT100 terminal emulation
software. The console port is implemented as a data terminal equipment
(DTE) connector.
The following equipment is required to use the console port:
VT100-compatible terminal or a computer with a serial port running
VT100 terminal emulation software, such as Microsoft HyperTerminal.
A serial cable (provided) with an RJ-45 connector for the console port and
DB-9 connector for the terminal.
Perform the following tasks to connect a terminal to the switch console port:
1 Connect the DB-9 connector on the serial cable to the terminal or
computer running VT100 terminal emulation software.
2 Configure the terminal emulation software as follows:
a
Select the appropriate serial port (for example, COM 1) to connect to
the console.
b
Set the data rate to 9600 baud.
c
Set the data format to 8 data bits, 1 stop bit, and no parity.
d
Set the flow control to none.
e
Set the terminal emulation mode to VT100.
f
Select Terminal keys for Function, Arrow, and Ctrl keys. Make sure
that the setting is for Terminal keys (not Microsoft Windows keys).
Getting Started Guide
23

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

N1524N1524pN1548N1548p

Tabla de contenido