Preparing The Remote Control For Use - Bosch CAD 12 Instrucciones De Manejo

General notes | Preparing the remote control for use
DVD country codes
Part number Country code
7 620 210 015 RC2 (Europe)
7 620 210 020 RC1 (NAFTA)
7 620 210 021 RC4 (Latin America)
7 620 210 022 RC5 (Africa, Asia)
Robert Bosch Car Multimedia GmbH
Preparing the remote
control for use
When you operate the device for the first time,
you must first insert the batteries in the remote
control.
Inserting the batteries
f Open the battery compartment by
removing the cover.
f Insert the new batteries. Battery classifi-
cation: Two AAA batteries. Make sure that
the battery poles are positioned as shown
in the battery compartment.
f Close the battery compartment.
Selecting the IR input
The device may be installed in a location where
the integrated IR sensor O cannot be reached
by the remote control. In this case you can
install an optional external IR sensor
(7 607 005 726) in a suitable location and
connect it to the device via chamber D of the
ISO connector. If the external IR sensor is to be
used, you have to select the IR input via
chamber D.
To toggle between the IR input via chamber D
(REAR IR) and the integrated IR sensor O
(FRONT IR),
f press the MENU G button to open the
menu.
f Press the MENU G button repeatedly
until "REAR IR" or "FRONT IR" appears on
the display.
f Turn the volume control B to the left or
right in order to switch between the
settings.
7 620 210 015/020-022 | 06.2015
en | 41